Here's what you'll need to bend and assemble your doggie bowl.
Turn the wire upwards 30 degrees immediately after each of the two short lengths have been bent; we cut a 30-60-90 wedge out of foamcore but you could also use an angled magnet...or just eyeball it.
You'll end up with two rotated halves and a dodecagonal base.
Clip them together using some 3D printed parallel clips.
Place a bowl that fits snug, put in some treats and let your dog enjoy it!
2 Lengths .125" Steel
Wire Cutters, 30-Degree Wedge, 3D Printed Clips, Wire
30 minutes - 1 hour